Butyl rubber gloves

The butyl rubber gloves are also called operation box gloves, long arm gloves, scientific research gloves. The diameter of the cuff can meet the diameter of the hole of the glove box box is in the range of 22-25 cm. There are curling at the cuffs and can be locked in the glove box. The hole in the box. Synthetic rubber gloves lined with nylon fibers. It is divided into large, medium and small sizes. Has high physical and mechanical properties and tear strength, acid and alkali resistance, excellent wear and air tightness, anti-aging properties.
Butyl rubber gloves are suitable for use in the glove box, anaerobic tank, incubator, and operation box. Excellent resistance to hydrofluoric acid, aqua regia, nitric acid, strong acids, strong bases, toluene, alcohol, etc., special rubber synthetic resistance liquid gloves. Mainly applicable to electronic industry, biopharmaceutical industry, electroplating industry, food production base Industry, chemical, university research laboratories and other industries.
Butyl rubber gloves need to be checked for airtightness before use: Blow into the gloves and squeeze the cuffs of the gloves to see if the gloves will leak on their own. If a glove leaks, it should be discarded.

  
1. Lengthen the butyl rubber gloves seal ring (Φ196-197MM):
The butyl rubber glove's sealing and fixing ring is made of acetal copolymer. It is a tough and rigid thermoplastic engineering plastic with good impact strength and surface hardness, good dimensional stability and certain chemical resistance. Good corrosion and oxidation resistance, long-term use in the temperature range of -40 ~ 104 °C.
A plastic seal retainer consists of an inner ring and an outer ring. The diameter of the round hole on the glove box panel is 196Phi; 196-197mm. The inner ring and outer ring of the sealed plastic ring are installed separately from the box body during installation. The outside of the box is tightly attached to the surface of the transparent panel to form a nip to clamp the glass panel, and then the inner ring and the outer ring are screwed in the box.
Since the inner ring and outer ring are equipped with rubber O-rings on the glass side, they can provide a good sealing effect. Self-tapping screws do not penetrate the glass when tightening the inner and outer rings. The glove is tightly fixed on the cylindrical surface of the glove's fixing ring protrusion, and a rubber tightening ring or metal clamp may be put on the glove to ensure that the glove is tightly fitted on the outer ring without shifting.
2. Compatible rubber O-rings, rubber tensioning rings, metal hose clamps:
The rubber O-ring ensures the sealing performance between the panel and inner ring, panel and outer ring. Rubber tensioning rings and metal hose clamps tighten the gloves to prevent them from slipping and falling off.

Commercial Plywood

Black Film Faced Plywood,Phenolic Film Faced Plywood,Commercial Plywood

Melamine MDF Co., Ltd. , http://www.luliboard.com

This entry was posted in on