How to install the toilet accessories installed toilet accessories

The toilet, we all know for sure, because it is a sanitary ware in the bathroom space, then you know the toilet installation? Perhaps most people don't understand it. There are certainly toilet parts in toilet products. Today we will take a look at the installation of toilet accessories.

Toilet principle

The flush toilet is mainly composed of two parts of the water tank and the toilet. There is almost no difference between the traditional toilet tank and the main body. However, the modern flush toilet principle has given up the flushing way of the traditional toilet, mainly the siphon principle.

The specific working principle of the flush toilet is: the “pumping” of the flush toilet refers to the S-shaped bend under the toilet. When the sewage in the toilet exceeds the high point of the S-bend, the formed siphon phenomenon can make the water of the toilet flush. The dirt was taken away. Until only a small amount of water remains, the siphon is destroyed, leaving behind a small amount of water, forming a water seal.

Toilet Accessories Installation Procedure

1. Determine the installation location and drill holes on the ground. After aligning the floor drain nozzle with the drain outlet at the bottom of the toilet bowl, according to the outer dimensions of the toilet bowl base, the position of the fixing hole of the toilet bottom corner is drawn on the floor, and the hole is drilled with a percussion drill. The hole depth is about 5 cm.

2. Install the toilet seat. Drill the steel expansion bolt into the ground hole, insert the bottom corner of the toilet into the expansion bolt and tighten the nut to place the toilet. The toilet sewage outlet and the ground pre-determined drain pipe should be tightly connected and sealed.

3, install the water tank (one-piece type toilet does not need this step) according to the height of the tank installation and the position of the hole in the rear wall of the tank, drill holes in the corresponding fixed position on the wall and knock in the steel expansion bolt, then place the water tank in place, so that Insert the expansion bolt into the hole of the wall, add a 3 mm thick nylon washer, and then tighten the nut.

4. Install the connecting pipe (using copper or plastic pipe, etc.) between the tank and the toilet base, and the connecting pipe (using stainless steel bellows, etc.) between the inlet pipe and the bottom of the tank. Inlet pipe connection should be installed angle valve (water inlet control valve).

5. Install floats and other accessories inside the tank.

6. After opening the inlet valve, adjust the floating height of the float according to the required inlet height in the tank, and adjust the tightness of the control screw according to the size of the spray valve.

7. After the tank is filled with water, check the toilet discharge capacity and whether there are any water leakages at the connection points of the pipes.

8. Seal the gap between the toilet seat and the floor with putty or silicone. Do not use cement paste or cement mortar as sealing material.

9, install the toilet seat and toilet seat cover.

About pumping toilet accessories installed on the introduction here, I hope for your help, more exciting content, all in this site, so stay tuned.

More articles:

Small family bathroom recommended what is a wall toilet

What are the barrel sizes of healthy and comfortable bathroom products?

What shower room ten shower room recommended

Toilet brand recommended toilet which brand is good

Toilet

Isotropic Rubber Magnet

Magnetic Rubber Sheet,Roll Magnet,Sheet Magnetic Roll,Adhesive Magnetic Tape

Honesun Industrial Co.,Limited , https://www.chinamagnetise.com

This entry was posted in on