Want to make your new pump back more durable? Come and watch the 9 feasibility suggestions from Dalan Hydraulics!
Want to make your new pump back more durable? Come and watch the 9 feasibility suggestions from Dalan Hydraulics!
1. If the oil pump that has been bought back is not used in time, the inside should be injected with anti-rust oil, and the exposed surface should be coated with anti-rust grease, and then the oil port dust cover should be covered.
2. The regulating pressure of the safety valve should not be too high, generally 1.25 times the rated pressure of the pump.
3. Keep the oil temperature in the range of 10 °C-60 °C, especially avoid high temperature continuous operation, otherwise the life of the oil pump will be greatly shortened. Set the heater and cooling unit if necessary.
4. Maintain normal oil level. A oil level gauge should be placed in the fuel tank for frequent observation and replenishment.
5. Regularly check the performance of the oil. If the requirements are not met, replace it and clean the tank.
6. The oil filter should be cleaned frequently to ensure the smooth suction of oil.
7. After the oil pump has been working for a period of time, the screws may be loosened due to the installation screws or the inlet and outlet ports. Pay attention to the inspection and tighten the lock.
8. The maximum hydraulic impact force of the system shall not exceed 14Mpa.
9. In order to clarify the temperature of the hydraulic oil, it is necessary to know the relationship between the working temperature of the oil in the tank (open circuit) and the temperature of the environment. The temperature of the leaking oil (shell drain) is affected by the pressure and speed of the pump and is always higher than the tank oil temperature. However, the maximum temperature anywhere in the system must not exceed 90 degrees.
----- Editor-in-Chief: Dalan Oil Pump Motor 02-Procurement Consultant
Copyright http: / (Dalan Motor) Reprint, please indicate the source
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
The selective coating on the inner cover of the Vacuum Tubes converts solar energy and transfers heat to the heat pipes by aluminum fins. The liquid in the heat pipe changes into vapor which rises to the condenser. Then the heat passes through the heat exchanger, the water inside of water tank is being heated, and the vapor becomes liquid, returning to the bottom of the heat pipe. This transference of heat creates a continuous circulation as long as the heat pipe vacuum tube collector is heated by sun.
Heat is transferred by liquid to the water tank and heat the water efficiently. In addition, heat pipe vacuum tubes is highly freezing resistance, which ensures higher efficiency in cold areas.
Pressurized water tank ensures high comfort when customer uses hot water, the water flow and water pressure is much higher than compact non-pressurized solar water heater.
Heat Pipe Solar Water Heating System
Solar Hot Water System,Solar Tube Hot Water System,Heat Pipe Solar Water System,Heat Pipe Solar Water Heating System
Linuo Ritter International Co.,Ltd , https://www.lnrtsolarenergy.com