First, the wall spray machine construction process flow construction preparations → wall cleaning, wetting → grassroots processing → hanging vertical, sets of square, plastering cake → door window frames, junction boxes and other protection → on-site mixing 1:1 cement mortar → machinery Spray the bottom mortar → wipe the surface mortar → curing.
Second, the wall spray gun safety operation guide access 2.5 square four-phase cable, there must be a stable 380V access power supply.
Before starting the machine, check carefully whether the contact wires of the electrical appliances are firm and whether the cable ends fall out.
Carefully check the fastening screws of the body.
Check carefully if there is any foreign matter inside the hopper to prevent it from catching the stirring blade. Before turning on the power, first turn the stirring shaft by hand to facilitate starting. In cold weather, you can first add the appropriate amount of silicone oil to lubricate the stirring shaft.
Before loading the material, be sure to stir the outside well, pour into the hopper, and further stir. Before mixing the material in the hopper, close the discharge valve, open the recharge valve, and then open the discharge valve and close the return valve after mixing.
After everything is properly installed on the sprayer, activate the master switch to activate the air compressor switch to see if the direction of rotation of the air compressor wheel is consistent with the arrow.
Start the inverter: Press Run to observe whether the index is 00:00 and then rotate the control button, according to the situation to adjust the speed, press STOP when stopped, and then adjust the rotation control button to the starting position.
After the work is completed, rinse the body with clean water to clean the piping system. Remember not to rush into the circuit system and the motor.
Third, the wall sprayer Note Sprayer wiring must be connected to the grounding line, after the wiring must be firmly insulated tape.
When flushing the body, carefully enter the motor.
Be sure to check for proper amount of oil in the compressor.
Be sure to clean the hopper after use, flush the inside and outside of the pipeline.
Do not insert it into the hopper by hand when stirring.
Do not touch the air compressor or motor when it is rotating.
T-Connectors are used in overhead power lines or at substations to divert electric current from the main line of the busbar in a T shape. It is mainly divided into two types: bolt type and compression type. For wires with small cross sections, parallel groove clamps and plier compression oval splicers can also be used as T-connectors.
Specification
1) High quality of the T-Connector
2) Stable structure (Type TY)
3) Certificate: ISO9001
4) Prompt quote & Leadtime guarantee
If you have any questions, please contact with us directly.
Our company is solemnly committed to the majority of customers: reasonable price, short production cycle, considerate service. We look forward to cooperating with you.
T-Connector
Tly Type T- Connector,T-Connector For Single Conductor,Hydraulic Compression T-Connector,Compression T-Connector
Shandong Vantage International Trade Co., Ltd. , https://www.steelplate.be