How to install TIMKEN cylindrical bore bearing

Source: China Bearing Network Time: 2018-05-10

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

TIMKEN is a separate bearing unit because the inner and outer rings can be easily attached to the shaft or housing. At this point, it should be paid attention to when the shaft of the inner ring is now inserted into the bearing box with the outer ring installed; try to make it adhere to the concentric; to prevent the roll and the raceway from being scratched. For the TIMKEN bearing inner ring When the shaft is tightly engaged with the shaft, and the outer ring bearing housing hole is a loosely coupled non-detachable bearing device;
The device for the separate bearing can be easily attached to the shaft or the bearing housing because the inner ring and the outer ring can be easily removed. At this point, it should be paid attention to the fact that the shaft that has been installed inside the inner ring is pierced into the bearing box with the outer ring installed; try to keep it concentric; to prevent scratching the rolling body and the raceway.
For the TIMKEN imported bearing inner ring and the shaft tightly cooperate, the outer ring bearing housing hole is a loosely coupled non-detachable bearing device; the bearing can be first mounted on the shaft; then the shaft is mounted together with the bearing to the bearing Inside the seat hole; if the bearing is small; you can also use a soft metal hammer to tap the end face of the ferrule to force the bearing to arrive; but the tapping force must be evenly distributed on the bearing ring.
The bearing outer ring and the bearing housing hole are tightly cooperative, and the inner ring and the shaft are loosely coupled; the bearing can be first mounted on the shaft.
When the TIMKEN bearing ring is tightly engaged with the shaft or housing bore, a special device sleeve is used to press the bearing onto the shaft or housing.
When the TIMKEN bearing scale is large; because the required device force is large; or the bearing cooperation with heavy load operation is too large, it is difficult to select the cold state device; then the bearing inner ring or the bearing housing is heated beforehand. Then carry out the device. In the hot state device; the heating temperature should be strictly controlled. When heating the bearing; the heating temperature should not exceed 1200C; usually it should be 80~1000C. The bearing with dust cover or sealing ring can not be heated; otherwise it will form lubrication The agent is lost. The heating method can be selected by electric induction, oil bath heating, etc.

Recommend to friends comments close window

Bearing related knowledge

The layout and use of thrust cylindrical roller bearings
MMX (machine tool bearing)
Analyze the specific analytical skills of radial ball bearings: the skills of overhauling centrifugal pump bearings and the analysis of the limit speed and conflict coefficient of bearings

This article links to http://
Please indicate the bearing network http://

Previous:Analysis of the cause of abnormal damage of hub bearings Next:Discussing the smooth handling of textile equipment

Liquid Fertilizer is easy to use in various fertilization methods such as Foliar Spraying and Soil Side Dressing,especially in Aerial Application.

Liquid Fertililzer

Liquid Fertililzer,Clear Liquid Fertililzer,100% water soluble fertililzer,Liquid Fertililzer for Aerial Application

Hebei Monband Water Soluble Fertilizer Co., Ltd. , https://www.wsfertilizer.com