Wooden keel after laying to check the laying of solid wood flooring need to pay attention to 5 issues

After the wooden keel is laid, it must be checked.

The price of solid wood flooring is relatively high. If it is affected by improper laying, it may not be worthwhile. The following are a few places to take care when laying solid wood flooring, for everyone to wake up.

â—† Wooden keel must be checked

The unevenness of the ground caused some floors and wooden keels to hang, and the floor was easy to make noises. If the wood keel is not firm, it is easy to produce the same situation, so be sure to check it after it is finished. You can step on the wooden keel with your feet and check if it is firm by shaking your feet.

â—† The floor leveling work can not be forgotten

After paving the first row of floors, the installer should pull the straight line to measure the level. If it needs to be adjusted immediately, it will affect the laying of the back floor. After laying, it is better to take the ruler upright on the floor to see if there is any Gap.

â—† Wood keel to do drying and flood prevention

The water content of a generally qualified solid wood floor is 12%, and the wood keel must be dried so that the wood floor will not absorb moisture quickly due to a large humidity difference, resulting in floor arching and paint burst. The solid wood flooring has good log properties and is prone to worms. Therefore, it is necessary to put swarf into the wooden keel. The standard is to put one kilogram of smashed wood chips per 8 square feet, and be careful to put it evenly.

â—† The color difference problem pays attention in advance

The color of each solid wood floor will be different, so you should pick out the floor with similar color and texture before the formal laying, so that the overall pavement effect will not be much different.

â—† The laying of moisture-proof mats

In order to prevent the water vapor on the wall from “infecting” the solid wood floor, when laying the moisture-proof pad, it is necessary not only to cover the entire wooden keel, but also to keep the moisture-proof pad up to about 10 cm along the corner of the wall. At the same time, expansion joints should be left between the wooden floor and the wall. If it is put too close, the floor will bulge easily after expansion.

Floor installation decoration construction knowledge wooden floor paint

Poly Solar Panel

Mono Solar Panel ,Monocrystalline Solar Panel Co., Ltd. , http://www.chsolarpanels.com

This entry was posted in on