Home>Bearing knowledge>Cylinder type inner bore inlet bearing device |
Cylindrical inner bore inlet bearing device
/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
The bearing outer ring and the bearing housing hole are tightly cooperative, and the inner ring and the shaft are loosely coupled; the bearing can be first mounted on the shaft.
When the bearing ring is tightly engaged with the shaft or housing bore, a special device sleeve is used to press the bearing onto the shaft or housing.
The device for the separate bearing can be easily attached to the shaft or the bearing housing because the inner ring and the outer ring can be easily removed. At this point, it should be paid attention to the fact that the shaft that has been installed inside the inner ring is pierced into the bearing box with the outer ring installed; try to keep it concentric; to prevent scratching the rolling body and the raceway.
When the bearing scale is large; because the required device force is large; or the bearing cooperation with heavy load operation is too large, it is difficult to select the cold state device; then it is necessary to heat the bearing inner ring or the bearing seat beforehand. Carry out the device. In the hot state device; the heating temperature should be strictly controlled. When heating the bearing; the heating temperature should not exceed 1200C; usually it should be 80~1000C. The bearing with dust cover or sealing ring can not be heated; otherwise it will form lubricant Lost. Heating method can be selected by electric induction, oil bath heating and other methods.
Recommend to friends comments close window
Bearing related knowledge |
Bearing processing heat treatment process and skill application role of bearing removal, overhaul and discriminating the use of spindle bearing oil function Grinding machine static pressure bearing repair experience Talk about the explanation of the alignment of the drill bearing |
This article links to http://
Please indicate the bearing network http://
Previous:The five main rules of the sliding bearing are as follows: Analysis: The method of bearing rust prevention
XB300 Asbestos Jointing Sheet
XB300 Asbestos Jointing Sheet is pressed with chrysotile asbestos fibers and synthetic or natural rubber as the main materials.
Usage:Suitable for temperature max 300 centigrade in water,vapour,air,gas,ammonia alkali and other mediums transmitted in the joints of facilities and pipelines.
PRESS:3.0MPa(max)
Dimension:
4100×1500mm; 4500 x 1500mm;2000×1500mm;
1500×1500mm;1500×1000mm;1540x1360mm
1270×1300mm; 3810×1300mm
Thickness: 0.5~6.0mm
Technical data:
Lateral Tensile Strength/MPa ≥ 9.0
Aging coefficient ≥ 0.9
Loss on ignition/% ≤ 30.0
Compression ratio/% 7~17
Recovery/% ≥ 40
Creep relaxation rate/% ≤ 50
Density(g/cm3) 1.6~2.0
Xb300 Asbestos Jointing Sheet,Asbestos Jointing Sheet,asbestos rubber jointing sheet,Compressed Jointing Shee
HEBEI HENGDA SEALING MATERIALS CO.,LTD. , http://www.hengdasealing.com